If the camera connects but the status indicator does not turn green, restore the camera to default settings.Įnsure that the camera is connected to the NVR via an Ethernet cable. REMINDER: The camera may take up to 2 minutes to display after initially connected.Ĭlick Add, the status indicator will turn green if the camera is successfully connected.Īfter approximately 2 minutes the camera video feed will display. Wait 30 seconds, reconnect and search again. If the camera does not show up in the search results, disconnect the camera. This may take several seconds depending on the network strength. The system will search the network for compatible cameras. Refer to your user manual for your default Username and Password.Ĭlick Device Search. Log in using your administrator login information. Right-click on the Live View to access the Quick Menu. The following instructions require you to access your system using your NVR and a monitor. If your camera is connected to the NVR using a router or PoE switch: Click here for downloads and documentation for your product. View your PTZ camera user manual for further information if this is available on your model. LIMITATION: Not all PTZ cameras have a manual reset option. Hold the button for 15 seconds before releasing. While still holding the reset button, disconnect and reconnect the Ethernet cable. Press and hold the reset button below the camera module for at least 10 seconds. Use the Allen key included with the camera mounting kit to loosen the dome camera cover screws. To restore the camera to default settings:Įnsure that the camera is connected to the NVR via an Ethernet cable and is receiving power. If the video feed is still not visible, restore the camera to default settings. If available, use an Ethernet cable that is connected to a functioning camera. Try connecting using a different, functional Ethernet cable. If the video feed is still not visible, there may be an issue with the Ethernet cable.If after 2 minutes the video feed does not display, disconnect the camera from the NVR, wait for 30 seconds, and reconnect.The camera may take up to 2 minutes to display after initially connected. If your camera is connected directly to an NVR using an Ethernet cable: Do not use anything other than water to clean the dome cover, chemicals such as acetone can permanently damage the plastic. IMPORTANT: For best picture quality, ensure the camera dome cover is clean. Image quality will degrade if the maximum recommended cable length is exceeded. Ensure that the Ethernet cable length does not exceed the guideline set in your product specifications sheet. Images are simulated.If the video feed of a channel using a Pan-Tilt-Zoom (PTZ) camera is not visible, there may be an issue with the camera or its connection. We reserve the right to change models, configurations or specifications without notice or liability. No claim is made to the exclusive right to use the trademarks listed, other than the trademarks owned by Lorex Corporation. For instructions on enabling H.265 compression, visit /supportĪll trademarks belong to their respective owners. You must connect the camera to a supporting H.265 NVR to take advantage of H.265 compression. Installation in a sheltered location recommended.Ĥ. Please note that the following minimum upload speeds are required for remote video streaming: 5 Mbps for 4K video. Ensure your recorder is up-to-date with the latest firmware version. In total darkness (zero Lux), the camera will not produce a night time image and therefore the camera should not be installed in completely dark areas.ģ. Connect your recorder to your router using an Ethernet cable (see the Quick Setup Guide Guide 1/2 for details). The camera requires ambient lighting (for example, street/ building lighting, star or moon light) to render a night time image. This camera features an ultra-low light sensitive image sensor and therefore does not feature Infra-Red LEDs. For the most up-to-date list of compatible recorders, visit 2. Compatible with all Lorex HD NVRs except for LNR200 & LNR300 Series.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |